Description
The patented Protector XStream Laboratory Hood was engineered to be the best containing fume hood. Testing shows the Protector XStream easily meets containment per SEFA-1 low velocity hood standards when subjected to the ASHRAE 110 test protocol with results of less than 0.05 ppm leak rate when tested at 4.0 lpm at OSHA-recognized 60 fpm face velocity.
The Protector XStream models feature:
• By-pass airflow design with variable air volume compatibility
• Eco-Foil Air Foil with aerodynamic Clean-Sweep airflow openings
• Cord-Keeper Slots on left and right side of air foil
• Upper Dilution Air Supply
• Glacier white powder-coated steel exterior
• Rear Downflow Dual Baffle System
• Chemical-resistant, fiberglass-reinforced, composite panel liner and baffles with flame spread index less than 25 per ASTM
E84. Baffles are removable for cleaning
• Opti-Zone Baffle with tapered slots
• Tempered safety glass vertical-rising sash
• Powder-coated sash handle with aerodynamic Clean-Sweep openings
• 37.5 in. (95.3 cm) high sightline from the work surface to the header panel
• Removable front and side panels, and front and interior service access panels for access to plumbing and electrical wiring
• Pre-wired LED lighting with vapor-proof design and ADA-compliant light and blower switches. Lighting rated to 50,000 hours
• Sash stop located at 18 in. (45.7 cm) sash opening position
• Powder-coated stainless steel, 12.81 in. (32.5 cm) ID exhaust connection(s)
Fixtured models feature:
• Two pre-plumbed service fixtures with forged brass valves, lower right side with brass tubing for gas and lower left side with copper tubing for cold water. Components for converting either or both fixtures to air and vacuum are provided. Inlet tubing is not provided
• One pre-wired GFCI electrical duplex receptacle on lower right side and, on 8 ft. models only, one additional pre-wired GFCI electrical duplex receptacle on the lower left side
Required Accessories (not included):
• Remote Blower
• Ductwork
• Work Surface
• Base Cabinet or Stand
Image(s) are representative of the product group and not necessarily the individual product.